Raising the Mast
Not too much to report, but we are working on her.
The first thing was to raise the mast, so I fabbed up a quick a-frame to help raise it. I took an old deck board and ripped it down the middle.
I cut it to length to match the distance from the side stay chain plates to the forward stay plate. It was about 11'-8" long. I drilled 3/4" holes in the ends of both boards. I ran a piece of 1/2" line through the ends of each board and connected them to
make the a-frame. I the other ends to the chain plates. One on each side. I connected the forward
stay to the loop on the point of the a-frame and also a block and tackle which I connected to the forward stay plate.
I should have taken more pictures.
The first thing was to raise the mast, so I fabbed up a quick a-frame to help raise it. I took an old deck board and ripped it down the middle.
I cut it to length to match the distance from the side stay chain plates to the forward stay plate. It was about 11'-8" long. I drilled 3/4" holes in the ends of both boards. I ran a piece of 1/2" line through the ends of each board and connected them to
stay to the loop on the point of the a-frame and also a block and tackle which I connected to the forward stay plate.
I should have taken more pictures.
Someone added cable clamps to connect the two side stays together. I guess they did this to get them out of your way. I wonder if this is okay or if it reduces the strength. It seems like it would be okay.
I need to ask this question on the South Coast Sailor Talk facebook page.



Comments
Post a Comment
Comments and words of encouragement are welcomed.
Motivation can sometimes be in short supply.